Message: Subject: Low profile heat sink By: Tbird (IP: 80.197.171.*) Written on: 04-01-2005 15:21 Hi, Can anyone help me out with a CPU heat sink for P4 socket 478? The most important is that is no higher than 30 mm, because I will need to have a papst 60x60x15mm fan on top - and I don't have a lot of space!!!

Replies: By: Tillmann (IP: 84.57.28.*) Written on: 05-01-2005 02:18 Hi, there are quite a few P4 heatsinks for 1U servers available, that are flat enough (even flatter than 30mm). One unit I recommend is the JagWire JAC322C. It is entirely made of copper and has very fine fins. The performance is good; I've also seen this heatsink being used in "brand name" 1U P4 servers. bye, Till

Back to index | Reply to this message Forum software based on code © Monstar.nl